To the extent not prohibited by law, in no event shall Danfoss be liable for any direct, special, indirect or consequential damages, whatsoever, including, without limitation, damage to property, damages for loss of savings or profits, or loss of data arising out of any use of the Application. Danfoss does not warrant that the Application will meet your requirements or that the operation hereof will be uninterrupted or error-free. The Application and results and information generated thereby cannot substitute technical advice but must be verified by the user, they are not promises and should not be relied on as accurate data or analyses.ĭanfoss disclaims all warranties and conditions regarding the Application, whether express, implied, or statutory, including, but not limited to, conditions of merchantability, satisfactory quality, fitness for a particular purpose, accuracy and non-infringement of third parties' rights. Install the new compressor and pressurized hoses.Installation of Coolselector®2 ("the Application") is provided on an "as is" and "as available" basis for the intended purposes as determined by Danfoss only and any use hereof is at the user's sole risk. Replace O-rings of the pressurized hoses. Take the car back to an auto shop and have them properly refill the refrigerant.Reconnect the hoses to the compressor and secure them with the two 10mm bolts.Replace the O-rings of the pressurized charge line and condenser hose connectors.With a torque wrench, tighten the idler pulley center nut to 33 ft lbs (refer to Figure 2).Re-install the compressor belt and tighten the 14mm adjusting bolt to a snug fit.With the four 12mm bolts, secure the new compressor to the mounting bracket.Loosen the bracket and pull the drier down. Install a new drier in reverse order to the removal process.įigure 4.From underneath the front end of the car, remove the bracket holding the drier in place.Pull out the suction line connected to the drier.With your 10mm socket and ratchet, remove the two bolts on top of the drier.The drier is located right below the windshield washer reservoir.When the compressor is disconnected, air manages to escape, and moisture can make its way into the system. This video audio editor app also lets you trim/cut both audio and video as well as merge your audio and video files. It can also convert video files into Audio formats like MP3, AAC, AC3, OGG, M4A, WAV etc. The A/C drier keeps moisture from building up inside the system. This converter & compressor supports converting, compressing, changing resolution, Frame rate (FPS), bitrates of a video file. Remove four 10 mm bolts from side of the compressor. Remove the four 12mm bolts on the side of the compressor that secure it to the engine.įigure 3.From underneath the engine, loosen the 14mm belt adjusting bolt and remove the compressor belt.įigure 2.Disconnect the electrical connector on top of the compressor.With a 10mm socket and ratchet, remove the hose connectors along with the hoses.From inside the engine bay, locate the pressurized charge line and condenser hoses connected to the top of the compressor.(Related Article: Honda Civic: How to Jack Up Your Civic - ) Figure 1. Slowly lift the front end and set it down on jack stands. Place hydraulic jacks under the front pinch welds of your Honda Civic.The A/C compressor is accessible from underneath the right-front-end of the car. If you do not have a proper A/C recovery machine at your disposal, take your vehicle to a certified shop and have it done there. The refrigerant contains toxic chemicals that are harmful to people and the environment.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |